The Flashbang Hoslter
The Flashbang is a molded plastic clamshell that is made to specifically fit each firearm. It holds the weapon securely and immobilizes the slide/cylinder and trigger.
Included with the Flashband are three suede straps that fit various bra band widths. To change sizes, simply undo the screw holding the snap and strap in place (be careful not to lose any of the pieces!) and move the strap to a different hole, or replace it with a different strap.
When the holster is adjusted to your liking, simply pop the gun into the clamshell with a firm push. It should snap into place and make the trigger inacessible while the firearm is inside.
Then tuck the gun and the holster up underneath the band of your bra so that the suede strap is centered between the cups of the bra. The bra band supports the holster and holds it in place. Ideally the grip of the gun should be far enough out from under the band that it is easy to grab, but enough of the gun and holster should be under the bra band that the firearm will stay in place without the support of the suede. Try moving the holster higher and lower until this perfect balance is achieved. Now stop and look at where the snap and strap are in relation to your bra band. If it looks like things would line up better if the strap was flipped over then take it back off, loosen up the screw and rotate the strap 180 degrees. If everything lines up perfectly, just snap the security snap and you're all set!
*Fit for a S&W Bodyguard .380 shown below, select your fit from the drop down box above*